Blog by Steve Laug
This is the fourth pipe from the box of pipes that I was gifted by a good friend of mine with the instructed purpose of cleaning them up and selling them with all of the proceeds going to the aid of earthquake victims in Nepal. Once again all funds raised will all go to the SA Foundation, and organization that has worked in Nepal for over 15 years helping provide recovery, housing and job training for women who are victims of sexual exploitation and trafficking. The ongoing earthquakes (over 300) that continue to shake Nepal have left much in ruins. The SA Foundation Project there was able to find new housing for the women and help with staff as well. Every dollar raised from the sale of these pipes will go to the work in Nepal.
This one is a little Jobey pipe has the typical Jobey fitment system with the tenon in the shank and the stem sliding over that. However that is where the typical ends. It is open for a 9mm filter and in this case a 9mm meerschaum filter. The pipe is stamped on the underside of the shank on the left side with the words Jobey over Meerschaum over Filter and on the right side it is stamped 300.
The finish on the bowl was in great shape, just dirty. The bowl itself needed a light reaming. The stem was dirty, oxidized and had straightened over time. There was a small nick on the top of the stem about mid-point. The inside of the bowl, shank and stem were dirty with tars and oils. There was no filter moldering away inside the shank which I was glad to see.
I did some searching to find out about the filters that were used. I found some pictures of the meerschaum filters that were used. I checked and the shank easily holds a regular 9mm filter from Vauen should the new owner wish to use one.
I set up the heat gun and heated the stem to deal with the bend first. I wanted to bend enough to give it a proper look. Once it was flexible I bent it over a wooden rolling pin that I use for this purpose.
I cleaned the shank and the airway in the bowl and stem with cotton swabs, pipe cleaners and alcohol until it was clean. It did not take much to clean it out. A few pipe cleaners and cotton swabs and it was clean. I used a medium and a fine grit sanding sponge to knock off the grime on the stem and work over the small nick on the top of the stem. Once I had it cleaned up I moved on to polishing the stem with the micromesh sanding pads. I wet sanded with 1500-2400 grit pads and then dry sanded with 3200-12,000 grit pads. As is my practice, I rubbed the stem down between each set of three pads with my Obsidian Oil Sock to give me continued traction in polishing the stem.
When I finished with the micromesh sanding pads I buffed the pipe and stem with Blue Diamond Plastic polish on the wheel and then gave it several coats of carnauba wax to preserve and protect. I finished by giving it a final buff with a clean, soft flannel buffing pad to raise the shine. The finished pipe is shown below. It should make whoever picks it up a decent smoking pipe.
This Jobey 300 bent brandy should make someone a great addition. If you are interested in this pipe email me with an offer at firstname.lastname@example.org and we can discuss it. The entirety of the sale price will go to the Nepal project. I will pay the postage so that does not get taken off the proceeds. If you are interested in reading about the SA Foundation you can look at their website at http://www.safoundation.com.
Thanks for looking.