by Steve Laug

Earlier this week I received an email from Steffen regarding a few more pipe projects that he had for me to work on. He dropped them off here yesterday for me to work on. There were six pipes in the lot. Two were his that I had worked on a few years ago – a Mayfair 1005 rusticated tree stump and a Jost Supreme. Both were favourite pipes of his. One was a Savinelli Bent Billiard that he purchased on a trip to Italy. The final three were pipes that belonged to his father who would soon be visiting him in Vancouver – a Brigham full bent four dot 4244, a Savinelli Portofino Bent Pot and a Bent Rhodesian with no name stamped on the shank sides. Steffen texted me this photo of the pipes before he sent them.This afternoon I decided to work on the first of Steffen’s father’s pipes. It is a rusticated Bent Pot. It is a beautiful grained piece of briar that I can appreciate why he chose it. There is a mother of pearl acrylic disc sandwiched between two brass bands on the end of the stem that provides a separation between the bowl and the vulcanite taper stem. The pipe is stamped on the underside of the shank and heel of the bowl and reads Portofino [followed by] Italy below and to the right [followed by] Savinelli [over] Product. The briar is dirty from use with a moderate cake in the bowl and an overflow of lava on the rusticated rim top. The stem was oxidized, calcified and had some tooth marks and chatter on the top and underside of the stem ahead of the button. There is no stamping on the side of the stem as it was unmarked. It also looked to have been made for a Savinelli Balsa Filter. I took photos of the pipe before I started my work on it. I have included them below. I took a photo of the stem surfaces and the bowl and rim to give a sense of condition of the pipe. You can see the cake in bowl and the lava overflow on the edges and rim top of the bowl. The stem surface is very dirty and you can see the tooth marks and chatter on both sides ahead of the button.I took a photo of the stamping on the sides of the shank. It is clear and readable as noted above. I also took a photo of the bowl with the stem removed. It is a great looking pipe.I cannot find any specific information on the Savinelli Product Portofino Rusticated Pot online. I found pipes for sale on Worthpoint and other sites that were both smooth and rusticated so the name does not imply rusticated pipes. Portofino is a village in NW Italy, SE of Genoa: tourist resort. The brand is thus part of a collection of pipes made by Savinelli named after villages in Italy. I have included a photo of the village from a tourist site.Now it was time to start working on the pipe itself. I reamed it with a PipNet pipe reamer using the second and third cutting head to trim the cake back. I used a Savinelli Fitsall Pipe knife to clean up the remnants leaving bare briar. I sanded the bowl walls with 220 grit sandpaper wrapped around a piece of dowel. The bowl was significantly cleaner. I scrubbed the externals of the bowl with a tooth brush and some undiluted Muprhy’s Oil Soap.  I rinsed the bowl down with warm water to remove the debris and dust. The bowl looked muc better. I worked on the rim top with a brass bristle wire brush to clean up the debris on the rim top. It looked significantly better.I cleaned out the airway in the shank and mortise as well as the stem with cotton swabs, pipe cleaners and isopropyl alcohol. It was dirty but it cleaned up very well.   I rubbed the bowl down with Before & After Restoration Balm. I worked it into the surface of the briar with my fingertips. It works to clean, restore and preserve the briar. I let it do its magic for 15 minutes then buffed it off with a cotton cloth. The pipe looks very good at this point in the process. I set the bowl aside and turned my attention to the vulcanite taper stem. I scrubbed the surface of the stem with Soft Scrub to break through the oxidation, calcification and clean up the tooth marks.I filled in the tooth marks on the stem surface and on the surface of the button on both sides with black CA glue. The glue I use has both rubber and carbon in the mix that harden as it dries but does not become brittle. Once it cured I flattened the repairs and reshaped the button edge with a flat needle file. I cleaned up the repaired areas with 220 grit sandpaper. I sanded the stem with 320-3500 grit sanding pads. I wiped the stem down after each sanding pad to remove the sanding debris and dust. The stem looked very good. The stem was drilled to fit a Savinelli Balsa System filter. I removed a new filter from the package of Balsa filters and fit one in the tenon of the stem. It fit well and looked good.I polished the stem with micromesh sanding pads – 1500-12000 grit pads. I wiped it down with an Obsidian Oil cloth after each sanding pad. I finished polishing it with Before & After Pipe Stem Polish – both Fine and Extra Fine and buffed it off with a cotton cloth. I gave it a coat of Obsidian Oil to preserve and protect the stem. This Savinelli Product Portofino Rusticated Pot is a great looking pipe now that it has been restored. The mix of brown stains really highlight the grain under the rustication and the polished finish has depth. I put the vulcanite stem back on the bowl and carefully buffed the pipe with Blue Diamond on the buffing wheel. I gave the bowl and the stem multiple coats of carnauba wax on the buffing wheel and followed that by buffing the entire pipe with a clean buffing pad. I hand buffed the pipe with a microfiber cloth to deepen the shine. The finished Savinelli Product Portofino Pot fits nicely in the hand and feels great. Give the finished pipe a look in the photos below. The dimensions of the pipe are Length: 5 ½ inches, Height: 1 ¾ inches, Outside diameter of the bowl: 1 ½ inches, Chamber diameter: 1 inch. The weight of the pipe is 67 grams /2.33 ounces. I have five more of Stephen’s pipes to work on. Once I have finished I will get them back to him to enjoy with his father. Thanks for reading this blog and my reflections on the pipe while I worked on it.

As always, I encourage your questions and comments as you read the blog. Thanks to each of you who are reading this blog. Remember we are not pipe owners; we are pipe men and women who hold our pipes in trust until they pass on into the trust of those who follow us.