Blog by Bill Hein

Today I have an interesting Kaywoodie on the bench. This particular pipe is an early Flame grain. It has a shape number of 23C. This is interesting because 23C was used for two different pipes in the same era. 23C is a two panel apple shape. One is half bent, the other is a square shank. The one on my bench is a square shank. I imagine it is quite rare as this style was only made in 1947. This still has its 4 hole stinger. Below are the before pictures. Starting off I disassembled the pipe and tossed the stem into a oxiclean bath. While the stem was soaking I reamed out the bowl and filled it with salt and alcohol. After a few hours I removed the stem from the oxiclean bath and rinsed it off. To my surprise there wasn’t much oxidation. I knocked the salt out of the bowl and gave it a good rinse before setting it aside to dry.

While the bowl was drying out I ran alcohol soaked pipe cleaners through the stem until they came out clean. This can be tricky with Kaywoodie pipes as quite a bit of sludge builds up inside the stinger. The ball on this pipe wasn’t too nasty but I found a very narrow pipe cleaner, a piece of wire, or even a toothpick can come in handy cleaning out the holes. I took some heat and 500 grit wet sandpaper to remove the oxidation and lift the few tooth marks near the bit.

I buffed the stem, stinger, and metal shank insert with white diamond. I then buffed the bowl and stem with carnauba wax. I finished the pipe up by buffing by hand with a microfibre cloth until I achieved a near mirror like shine. Below is the finished pipe.